Ft897 Programming Software Drivers For The

Look at the section Ports (COM and LPT) to see if your device is listed.

You can have 9600 or 57600 baud.

COM port number is not correct.

The program CommTest (see below) is available on the website to help with diagnosing which Com port you are connected to and whether the radio can talk to the PC.

FT-857, FT-857D, FT-897, FT-897D using rear CAT socket ) the function of the CATLinearTuner socket is not set to CAT.

Use menu item 020 to change the setting to CAT.

FT-857, FT-857D, FT-897, FT-897D using rear CAT socket ) the function of the Mic socket is set to CAT.

Use menu item 059 to change the setting to NOR or RMT.

FT-857, FT-857D, FT-897, FT-897D you are using a programming cable that connects to the Mic socket.

The radio can only be programmed using a cable that connects to the 8 pin mini-din socket at the rear of the unit.

FT-857, FT-857D, FT-897, FT-897D your programming cable is of a type that is powered from the serial port.

Change the radio definition so that DTRY and RTSY are shown.

For the FT-847 make sure you have pins 2 and 3 crossed.

Be sure to check for bent pins or pins that have been pushed into the body of the plug due to incorrect orientation before insertion into the socket.

FT-780088008900 range of mobile transceiver (it has a 6-pin mini-din) and have plugged it into the Packet socket.

The correct cable for radios that use a mini-din has 8 pins and must be plugged into the CATLinear socket.

USB and PCMCIA serial connections.

Check to see that the option to Use alternative read method is ticked in the Options menu of the initial screen.

FTBasicMMO.

Please contact the author if the program has problems communicating with the radio.

CPU reset to sort out some oddity that has lodged itself in its memory.

This is a last resort procedure - do not use it without first contacting the author unless you dont mind losing all of your radios settings and memories.

Discovered in October 2020: The program does not successfully read the very early versions of the FT-847 that do not have two way serial communications for CAT control.

Using CommTest CommTest is a free program to help with checking communication between the radio and the PC.

It is available on the Download page of the authors web site.

This screenshot shows the communication from a radio after power on and then off.

The Com port that shows traffic when you power the radio onoff is the one to specify in the program.

USB attached devices If your PC does not have a serial port then you can either use a USB to serial adapter and connect a 9-pin programming cable, or use a programming cable that directly plugs into a USB socket.

Be aware that these USB to serial adapters and programming cables that plug directly into a USB port may be assigned a different Com port number by the operating system for each USB socket that you plug into.

You might have to change the Com port number in the program if you use a different USB socket otherwise you will get an error when trying to readwrite the radio.

To determine the correct Com port number do the following: 1.

Ft897 Programming Software Drivers For The

If no extra port is shown then you probably need to install drivers for the USB cableadapter.

An alternative way to determine the port number is to plug the USB cableadapter into the PC and then use the Windows Device Manager.